skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Interrogating fault memory > < Self-diagnosis of the Gateway
Initiating self-diagnosis
Initiating self-diagnosis
Special tools and workshop equipment required
t  Vehicle system tester -V.A.G 1552-
t  Diagnostic cable -V.A.G 1551/3, 3A, 3B oder 3C-
Test requirements
t  Check the coding of the dash panel insert by referring to the table of codes.
Test conditions
l  Fuses according to current flow diagram O.K.
l  Battery voltage at least 11.5 volts
l  all electrical components switched off
Connect vehicle system tester -V.A.G 1552-
The diagnostic connection is located in the storage compartment on the driver's side.
   
–  Connect vehicle system tester -V.A.G 1552- with appropriate cable.
–  Switch on ignition
  S01-0045
Readout on display:
  Note
If there is no readout on the display: → Operating instructions of vehicle system tester.
 
Vehicle system test               HELP
Enter address word XX
After approx. 5 secs the display will show:
t  6N0909601: Gateway No.
t  Gateway K <-> CAN: Designation of component
t  0001: Software version of the Gateway
t  Coding 00006: Coding of the Gateway
t  WSC 60081: Workshop code
  Note
Check coding with the table of codes → Chapter.
–  Press key.
 
6N0909601  Gateway K <->    CAN  0001  →
Coding 00006           WSC 60081
If one of the following messages appears in the display, carry out fault finding as stated in the fault finding programme in the diagnostic cable → Current flow diagrams and Fitting locations.
 
Vehicle system test               HELP  
The control unit does not respond!
 
Vehicle system test               HELP
Fault in communication set-up
 
Vehicle system test               HELP
K cable does not connect to earth
 
Vehicle system test               HELP
K cable does not connect to pos. term.
Press the key after fault elimination.
Overview of selectable functions
The following functions are possible:
02 - Interrogating fault memory → Chapter
05 - Erasing fault memory → Chapter
06 - Ending output → Chapter
07 - Coding control unit → Chapter
08 - Reading measured value block → Chapter
 
Vehicle system test               HELP
Select function XX

Interrogating fault memory > < Self-diagnosis of the Gateway