| –
| Disconnect plug connection -1- on ignition starter switch -2-. |
| –
| Remove the safety varnish from the securing screw -A-. |
| –
| Slightly loosen the fixing screws -A- and pull the ignition starter switch -2- in direction of arrow out of the steering lock housing -3-. |
Note | t
| When installing, the ignition/starter switch and the lock cylinder must be in the same position, e.g. “Ignition ON”. |
| t
| After tightening the two screws at the steering lock housing, secure them again with locking varnish. |
| –
| Installation is carried out in the reverse order. |
|
|
|
