Octavia Mk1
|
1 - | Top part evaporator housing |
t | Assembling the evaporator housing → Fig. |
t | Check the gasket at the suction channel, replace if damaged (it seals the suction channel to the passenger compartment) |
2 - | Fresh air flap and re-circulating air flap control motor -V154- |
t | Inspect proper operation → Chapter |
t | removing and installing → Chapter |
3 - | Screw |
4 - | Fresh/re-circulating air flap |
5 - | Evaporator housing - bottom part |
t | Assembling the evaporator housing → Fig. |
6 - | Fresh air blower -V2- |
t | removing and installing → Chapter |
7 - | Fresh air blower series resistor - N24- |
t | removing and installing → Chapter |
8 - | Evaporator |
t | Install seal on the refrigerant lines of the evaporator → Fig. |
t | Installing the seal on the evaporator → Fig. |
9 - | Seal |
t | Install seal on the refrigerant lines of the evaporator → Fig. |
10 - | Seal |
t | replace |
t | Installing the seal on the evaporator housing → Fig. |
t | seals the connecting area of the refrigerant lines to the engine compartment |
11 - | “O”-ring seal |
t | removing and installing → Chapter |
12 - | “O”-ring seal |
t | removing and installing → Chapter |
13 - | Threaded plate |
14 - | Expansion valve |
t | Removing and installing the refrigerant lines → Chapter |
t | removing and installing → Chapter |
t | Remove and install heat-protection insulation → Chapter |
15 - | Screw |
t | Tightening torque: 8 Nm |
|
Note
|
|