| Removing and installing the compressor |
| (Must only be performed in service centres!) |
| –
| Drain refrigerant circuit. |
| –
| Removing refrigerant lines from the compressor → Chapter. |
| –
| Remove compressor from the bracket → Chapter. |
| Installation is performed in the reverse order, pay attention to the following points: |
Note | Before the first operation of the compressor: |
| –
| Turn the compressor by hand approx. 10 turns |
| –
| Start engine with the compressor switched off. |
| –
| Wait until the idling speed has stabilised. |
| –
| Only then the compressor is switched on and must run at idling speed for at least 10 minutes. |
|
|
|
