Octavia Mk1
Note
|
| 1 - | Screw M8 x 80, 25 Nm |
| q | 4 pieces |
| 2 - | Washer |
| 3 - | Sealing ring |
| q | replace → Electronic Catalogue of Original Parts |
| 4 - | Screw for inspecting gear oil, 35 Nm |
| 5 - | Screw, M8 x 45, 25 Nm |
| q | 5 pieces |
| 6 - | Cover for gearbox housing |
| 7 - | Tensioning sleeve 5 x 22 mm |
| q | replace → Electronic Catalogue of Original Parts |
| q | removing and installing → Chapter |
| 8 - | 5th gear shift fork |
| q | removing and installing → Chapter |
| 9 - | Spring |
| 10 - | 5th gear sliding sleeve |
| q | removing and installing → Chapter |
| 11 - | Synchronizer body with sliding gear and synchronizer ring for 5th gear |
| 12 - | Arrester |
| q | 3 pieces |
| 13 - | Nut, 60 Nm |
| q | for drive shaft |
| q | always replace → Electronic Catalogue of Original Parts |
| q | to release or tighten the nuts observe mounting sequence → Chapter |
| 14 - | 5th gear pinion |
| q | Fitting position → Anchor |
| 15 - | Gearbox housing |
| q | repairing → Chapter |
| 16 - | Bushing for needle bearing |
| q | Fitting position: The oil pockets -arrow- point towards the 5th gear synchronizer body |
| 17 - | Needle bearing |
| 18 - | 5th gear sliding gear |
| 19 - | 5th gear synchronizer ring |
| 20 - | Supporting ring |
| q | prevents the arresters from wandering |
| 21 - | Disc spring |
| q | Fitting position: curved side points towards the cover of the gearbox housing |
| 22 - | Nut, 60 Nm |
| q | for output shaft |
| q | always replace → Electronic Catalogue of Original Parts |
| q | to release or tighten the nuts observe mounting sequence → Chapter |
