skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the master cylinder > < Removing and installing clutch pedal switch

Octavia Mk1

Summary of components - Hydraulics
Summary of components - Hydraulics
1 - Brake fluid reservoir
2 - Tubing
3 - Master cylinder
–  remove and install on left-hand drive vehicles → Chapter
4 - Mount
–  only replace if the master cylinder has been removed
–  removing → Fig.
–  installing → Fig.
5 - Clutch pedal
–  removing and installing → Chapter
6 - Self-locking nut, 25 Nm
–  always replace
7 - Support
–  fastened to support → Anchor.
8 - Tube-hose line
–  for left-hand and right-hand drive vehicles assign via the → Electronic Catalogue of Original Parts.
9 - Support
10 - Dust cap
11 - Vent valve
–  Bleed the clutch system → Chapter
12 - Slave cylinder
–  can be removed from shifting parts without disassembly
13 - Collar screw, 25 Nm
14 - Gearbox
15 - Locking clip
–  removing → Chapter
16 - Clip
–  Mounted at the structure
17 - Tube-hose line
–  for left-hand and right-hand drive vehicles assign via the → Electronic Catalogue of Original Parts.
18 - Pipe connection/plug connection
19 - O-ring
–  it is not separate as a spare part
–  in case of damaged O-ring, the complete tube-hose line must be replaced
20 - Locking clip
–  removing → Chapter
  S30-0024
Lift off the support -A- in -the direction of the arrow-.
  N30-0024
Push the actuator rod/master cylinder in the support -A- in -direction of the arrow-.
  N30-0025

Removing and installing the master cylinder > < Removing and installing clutch pedal switch