Skoda Workshop Service and Repair Manuals > Octavia Mk1 > Power transmission | Manual gearbox 02C | Final drive, differential, differential lock | Replace O-rings in rear final drive | Replace O-ring for shaft housing/Haldex coupling (final drive removed)

Replace O-ring for shaft housing/Haldex coupling (final drive removed)

Special tools and workshop equipment required

t	Engine mount for assembly stand MP9-101 -MP3-501-

t	2 screws M8

Removing

–	Clamp the rear final drive into the assembly stand.

–	Now unscrew all the fixing nuts for the secondary shaft housing -arrows-.

Note

The fig. only shows three nuts.

–	Remove the secondary shaft housing, to do so screw in the screws -A- evenly, so that the housing does not tilt.

–	Remove O-ring -A-.

Install

Installation is performed in the reverse order, pay attention to the following points:

–	Insert O-ring with gearbox oil.

–	Re-insert the adjusting washer(s) -B- with the same thickness.

–	Check the gear oil in the rear final drive → Chapter.

–	Check oil level in Haldex coupling → Chapter, if necessary change oil in Haldex coupling → Chapter.

Tightening torque

Secondary shaft housing to rear final drive

45 Nm

Skoda Workshop Service and Repair Manuals