skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Setting shank bevel gear > < Correct working sequence when re-setting the drive train

Octavia Mk1

When replacing the output flange, determine again the adjusting washer S4
When replacing the output flange, determine again the adjusting washer S4
Determining the adjustment is only necessary if the output flange is replaced. It serves to create again the preload of the tapered-roller bearing for the shank bevel gear.
   
–  Measure length of the shank on old and new output flange and determine the difference.
  V39-1076
Example:  
Old output flange25.80 mm
New output flange25.60 mm
Difference0.20 mm

If the new output flange is longer - fit a respective thinner adjusting washer S4.
If the old output flange is longer - fit a respective thicker adjusting washer S4.
The following adjusting washers are available:
   
Thickness (mm)Spare part No.
0,65
0,70
0,75		02C 409 280
02C 409 280A
02C 409 280B
0,80
0,85
0,90		02C 409 280C
02C 409 280D
02C 409 280E
0,95
1,00
1,05		02C 409 280F
02C 409 280G
02C 409 280H
1,10
1,15
1,20		02C 409 280J
02C 409 280K
02C 409 280L
1,25
1,30
1,35
1,40		02C 409 280M
02C 409 280N
02C 409 280P
02C 409 280Q

   

Setting shank bevel gear > < Correct working sequence when re-setting the drive train