skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
III - Removing and installing the drive shaft, output shaft (input shaft), differential and gearshift forks > < I - Removing and installing gearbox housing cover and 5th gear

Octavia Mk1

II - Removing and installing gearbox housing and shift mechanism
II - Removing and installing gearbox housing and shift mechanism
Special tools and workshop equipment required
t  Sealant -AMV188 200 03-
1 - Screw, 25 Nm
2 - Flange shaft with pressure spring
–  removing and installing → Chapter
–  complete → Chapter
3 - Screw, 30 Nm
–  for reverse shaft support
–  self-locking
–  always replace
4 - O-ring
–  always replace
5 - Bearing pins
6 - 22 Nm
7 - 22 Nm
8 - Cap
9 - Gearbox housing
–  repairing → Chapter
10 - Clutch housing
–  repairing → Chapter
11 - Tighten screw 25 Nm + 90°
12 - Shift mechanism
–  disassembling and assembling → Chapter
13 - 22 Nm
  S34-0307

III - Removing and installing the drive shaft, output shaft (input shaft), differential and gearshift forks > < I - Removing and installing gearbox housing cover and 5th gear