skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Replace gasket ring for right flange shaft - gasket ring and bushing are in two pieces|Install > < Replace gasket ring for right flange shaft - gasket ring and bushing are in two pieces

Octavia Mk1

Removing
Removing
–  If present, remove middle and right part of the noise insulation → External body work; Rep. Gr.50.
–  Turn steering to full right lock.
   
–  If present, remove heat shield for drive shaft from the engine -arrows- → Chassis → Rep. Gr.40.
  S39-0282
–  Unscrew the drive shaft -1- from the flange shaft → Chassis → Rep. Gr.40.
–  Tie up the drive shaft as far as possible. Avoid damaging the paintwork on the drive shaft during this operation.
–  Position the catch pan under the gearbox and the engine.
–  On vehicles with diesel engine, unscrew the oil return-flow line for the exhaust gas turbocharger from the engine, if present -arrow- → Engine → Rep. Gr.21.
–  Unscrew the fixing screw for the flange shaft; to do this, insert two screws in the flange and hold the shaft using a tyre iron.
–  Remove the flange shaft with pressure spring.
  N39-0824
–  Lever out gasket ring with screwdriver -A-, while doing so support the screwdriver on the cross member -3253/2 (MP6-414/2-.
  Note
t  Do not damage the bushing as this will cause leaks.
t  If damaged replace bushing → Chapter.
  N39-0823

Replace gasket ring for right flange shaft - gasket ring and bushing are in two pieces|Install > < Replace gasket ring for right flange shaft - gasket ring and bushing are in two pieces