skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing clutch pedal switch F36 > < Removing and installing the over-centre helper spring

Octavia Mk1

Removing and installing the clutch pedal
Removing and installing the clutch pedal
Removing
–  Remove the bottom left storage area on the driver's side → Body Work → Rep. Gr.70.
–  Remove clutch pedal switch -F36- (if present) → Chapter.
–  Removing the over-centre helper spring → Chapter.
–  Separate the clutch pedal from the master cylinder → Chapter.
   
–  Unscrew the nut -A- and pull screw out of the bearing bracket.
–  Remove clutch pedal.
Install
Installation is performed in the reverse order, pay attention to the following points:
  N30-0216
–  The support -A- must be located on the actuating rod -B- of the master cylinder.
–  Press the clutch pedal until its locks in -direction of arrow- and make sure it catches correctly.
–  Installing the over-centre helper spring → Chapter.
–  If present, install clutch pedal switch -F36- → Chapter.
  V30-0419
Tightening torque
ComponentNm
Clutch pedal to bearing bracket → Item

   

Removing and installing clutch pedal switch F36 > < Removing and installing the over-centre helper spring