skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Rear final drive > < Changing oil in the Haldex coupling

Octavia Mk1

Replacing oil filter for Haldex coupling
Replacing oil filter for Haldex coupling
Special tools and workshop equipment required
t  Key -T10066-
t  Catch pan
Removing
–  Place a catch pan under the rear final drive.
   
–  Slacken oil filter with wrench -T10066- and unscrew.
Fitting position: The oil filter -A- (covered by the assembly carrier) is located on the right vehicle side near the front bearing bracket -B-.
Install
–  Moisten O-ring of new oil filter with oil for Haldex coupling.
–  Screw in oil filter -A- and tighten with wrench -T10066-.
–  Check oil level in Haldex coupling → Chapter, if necessary change oil in Haldex coupling → Chapter.
  N39-0827
Tightening torque
ComponentNm
Oil filter in housing35

   

Rear final drive > < Changing oil in the Haldex coupling