skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Propshaft > < Measuring washer thickness S2

Octavia Mk1

Measuring washer thickness S1
Measuring washer thickness S1
   
S1=Stot. - S2 

   
Example: 
S1=2.70 mm - 1.65 mm
S1=1.05 mm 
    

  Note
Assign the adjusting washers via the → Electronic Catalogue of Original Parts.
Available adjusting washers for S1
   
Adjusting washer thickness (mm)
0,650,851,051,25
0,700,901,101,30
0,750,951,151,35
0,801,001,201,40

If the measured washer thickness is greater than the one listed in the table, 2 washers corresponding to the measured value may be fitted.
–  Insert determined adjusting washer S1.
  Note
On certain gearboxes, the adjusting washer S1 is located between oil deflecting washer and large cover. Here, the installed adjusting washer has to be first of all replaced through the originally installed oil deflecting washer in the same location.
–  Press in outer ring again.
–  Install large cover.
Perform control measurement - measure interlocking clearance
It should be in the range 0.15...0.20 mm.
   

Propshaft > < Measuring washer thickness S2