skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Differential gear for manual gearbox > < Replacing the angle gearbox output flange gasket ring (four-wheel drive)

Octavia Mk1

Setting overview (manual gearbox)
   
Setting overview (manual gearbox)
  Note
When working on the gearbox it is only necessary to re-set the drive shaft, output shaft gears 1 through 4, output shaft 5th/6th gear and reverse gear or differential gear if parts were replaced that directly affect the settting of the gearbox. To avoid unnecessary settings, refer to the following table:
  Set:
  Drive shaft only up to gearbox manufacturing date 18 05 3 (with tapered-roller bearings) → ChapterOutput shaft gears 1 through 4 → ChapterOutput shaft 5th/6th gear and reverse gear → ChapterDifferential gear → Chapter
Replaced part:Gearbox housingxxxx
 Clutch housingxxxx
 Drive shaftx   
 Output shaft gears 1 through 4 x  
 Output shaft 5th/6th gear and reverse gear  x 
 Differential gear housing   x
 Tapered-roller bearing for drive shaftx   
 Tapered-roller bearing for output shaft gears 1 through 4 x  
 Tapered-roller bearing for output shaft 5th/6th gear and reverse gear  x 
 Tapered-roller bearings for differential gears.   x

   

Differential gear for manual gearbox > < Replacing the angle gearbox output flange gasket ring (four-wheel drive)