skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the exhaust manifold - Engines with identification characters AEH, AKL > < Removing and installing the pre-exhaust pipe - engines with identification characters AEH, AKL

Octavia Mk1

Removing and installing the pre-exhaust pipe - Engines with identification characters AVU, BFQ
Removing and installing the pre-exhaust pipe - Engines with identification characters AVU, BFQ
Removing
  Note
Avoid a large deflection of decoupling element, max. deflection 10°.
   
–  Unbolt protective cover -arrows 1-, disconnect the 4-pin plug of the lambda probe and unhook the cable -A- on the heat shield -arrows 2-.
–  Unbolt heat shield for drive shaft.
–  Remove heat shield.
–  Detach clamping sleeve.
–  Unscrew pre-exhaust pipe from exhaust manifold.
–  Swivel pre-exhaust pipe down 180° and take off.
Install
Installation is carried out in the reverse order.
  S10-0160
Tightening order of pre-exhaust pipe to exhaust manifold.
–  Align exhaust system free of stress → Chapter.
–  Interrogate the fault memory → Vehicle diagnostic tester.
  N26-0008

Removing and installing the exhaust manifold - Engines with identification characters AEH, AKL > < Removing and installing the pre-exhaust pipe - engines with identification characters AEH, AKL