Octavia Mk1
Fuel tank with attached parts and fuel filter - Summary of components |
1 - | O-ring |
q | replace |
2 - | Gravity valve |
q | to remove, unclip valve and lift up and out of the filler neck |
q | inspect valve for blockage |
t | Valve in a vertical position: open |
t | Valve tilted 45°: closed |
3 - | Vent line |
q | to the activated charcoal filter system → Chapter |
q | clipped in place at top of fuel tank |
4 - | Screw cap |
5 - | Sealing ring |
q | replace if damaged |
6 - | Fixing screw |
7 - | Fuel tank lid unit |
q | with rubber bowl |
8 - | Vent valve |
q | to remove, unclip valve at side and take out of filler neck. |
q | before installing, unscrew screw cap -Pos. 4- |
q | check → Fig. |
9 - | Earth connection |
q | check for firm seating |
10 - | 10 Nm |
11 - | Vent line |
12 - | Fuel tank |
q | removing and installing → Chapter |
13 - | Circlip |
14 - | Heat shield |
15 - | 20 Nm + torque a further 90° (1/4 turn) |
q | replace |
16 - | 2 Nm |
17 - | Cover |
18 - | Tensioning strap |
q | pay attention to different lengths |
19 - | Feed line |
q | black |
q | to fuel rail |
20 - | Fuel filter |
q | Fitting position: arrow points in direction of flow |
21 - | Retaining clip |
q | for fuel filter |
22 - | Sealing ring |
q | moisten with fuel before installing |
q | replace if damaged |
23 - | Fuel delivery unit |
q | removing and installing → Chapter |
q | inspecting fuel pump → Chapter |
q | removing and installing the sender for fuel gauge → Chapter |
q | Test holding pressure → Chapter. |
24 - | Union nut, 80 Nm |
q | use wrench for union nut -MP1-227 (3217)- for removing and installing |
25 - | Feed line |
q | black |
q | to fuel filter |
q | runs to connection with marking „V“ at flange of fuel delivery unit |
26 - | Return-flow line |
q | blue |
q | from fuel rail |
q | runs to connection with marking „R“ at flange of fuel delivery unit |
27 - | Overflow hose |
Note
|