skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Disassembling and assembling engine > < Summary of components for vehicles with an air conditioning system

Roomster

Replacing the gasket ring for the crankshaft - flywheel side
Replacing the gasket ring for the crankshaft - flywheel side
Special tools and workshop equipment required
t  Assembly device -T10122-
l  Gearbox removed
–  Remove flywheel → Chapter (Pos. 8).
   
–  Remove the gasket ring carefully using a screwdriver -A-.
  Note
The adhesive surface must not get damaged when removing the gasket ring.
Install
  Note
The sealing lips of the gasket ring must be neither oiled nor greased.
  S13-0320
–  Push the assembly device -T10122/1- into the assembly device -T10122/2- and gasket ring -A-, then push onto the assembly device -T10122/2-, as shown.
–  Remove assembly device -T10122/1-.
–  Remove oil residue on the crankshaft journal with a clean cloth.
  S13-0356
–  Insert the gasket ring with assembly device -T10122/2 -.
–  Drive in gasket ring with assembly device -T10122/3 - up to the stop.
Further installation occurs in reverse order.
  S13-0357

Disassembling and assembling engine > < Summary of components for vehicles with an air conditioning system