Skoda Workshop Service and Repair Manuals > Roomster > Drive unit | 1.9/77 kW TDI PD Engine | Engine assy,cylinder block,crankcase

Securing the engine to the assembly stand

Special tools and workshop equipment required

t	Lifting device -MP9-201 (2024 A)-

t	Engine and gearbox mount -MP1-202-

t	Adapter -MP1-202/10-

t	Bushing -T30010 (VW540/1B)-

t	Assembly stand -MP9-101-

t	Workshop crane, e.g. -VAS 6100-

Work procedure

l	Separate engine from gearbox.

WARNING

Use securing pins on the hooks and rig pins to prevent release.

–	Attach lifting device -MP9-201 (2024 A)- at engine and at workshop crane (e.g. -VAS 6100-).

Belt pulley side: 2nd hole of the extension in Position 1.

Flywheel side: 4th hole of the extension in Position 8.

–	Lift off engine with installed engine mount -T10012- with workshop crane (e.g. -VAS 6100-) from engine/gearbox jack.

–	Remove engine mount -T10012-.

–	For carrying out assembly work, attach the engine with the engine mount -MP1-202-, the adapter -MP1-202/10- and the bushing -T30010 (VW540/1B)- to the assembly stand -MP9-101-. (The figure shows the 1.9ltr./47kW SDI Engine; the fixing system is identical).

Skoda Workshop Service and Repair Manuals