Superb
| Lubrication system - Overview of components |
| 1 - | 15 Nm |
| 2 - | Chain tensioner with tensioning rail, 15 Nm |
| q | When installing, pretension spring and attach |
| 3 - | Pressure relief valve, 27 Nm |
| q | Opening pressure: 0.13...0.16 MPa (1.3...1.6 bar) overpressure |
| 4 - | Oil injection nozzle |
| q | for cooling pistons |
| 5 - | Oil pump sprocket |
| 6 - | Dipstick |
| q | oil level must not exceed max. marking! |
| q | Markings → Superb |
| 7 - | Filler funnel |
| q | Remove for extracting oil |
| 8 - | Guide tube |
| 9 - | Dowel sleeves |
| 10 - | O-ring |
| q | replace |
| 11 - | Suction line |
| q | Clean strainer if dirty |
| 12 - | Baffle |
| 13 - | Support |
| q | for the intake manifold |
| 14 - | 25 Nm |
| 15 - | 45 Nm |
| q | connecting screws oil pan / gearbox |
| 16 - | 45 Nm |
| 17 - | Gasket ring |
| q | replace |
| q | cut open rolled up gasket rings |
| 18 - | Oil drain plug, 30 Nm |
| 19 - | 10 Nm |
| 20 - | Cover |
| 21 - | Oil level/temperature sender -G 266- |
| 22 - | Gasket ring |
| q | replace |
| q | oil before assembly |
| 23 - | Oil pan |
| q | removing and installing → Chapter |
| 24 - | Oil pump |
| q | with pressure relief valve 1.2 MPa (12 bar) |
| q | before installing, check whether both dowel sleeves for centering oil pump/cylinder block are present |
| q | If there is any scoring on contact surfaces and gears, replace |
| 25 - | Sprocket |
| q | Check fitting position |
| 26 - | 20 Nm |
| q | to release and tighten use the counterholder -T 10051- |
| 27 - | Chain |
| 28 - | Sealing flange |
| q | with gasket |
| q | must be positioned on dowel sleeves |
| q | removing and installing → Chapter |