Removing and installing crankshaft

Make

Skoda

Model

Superb

Section

2.0/85 kW engine › Enginecrankshaft group, pistons › Removing and installing crankshaft

EngineRemoving and installing crankshaft

Replace needle bearing for crankshaft Special tools and workshop equipment required t  Kukko 21/2 and Kukko 22/1 t  Centering mandrel -T 30029-   Note For installing an engine in a vehicle with manual gearbox, check whether the needle bearing is built into the rear of the crankshaft. Install the needle bearing as required. Removing

–  Pull out using an extractor -A-, e.g. Kukko 21/2 and Kukko 22/1. Install

–  Drive in using a centering pin -T 30029- t  The marked side of the needle bearing should be legible when in its installed condition

Depth of installation of the needle bearing t  Dimension -a- = 1.5 mm

01 Engine