Skoda Workshop Service and Repair Manuals > Superb > Power transmission | Automatic gearbox 01V | Automatic gearbox, gears, control | Removing and installing oil pan | Removing and installing oil pan (gearbox assembled)

Removing and installing oil pan (gearbox assembled)

Special tools and workshop equipment required

t	Catch pan, e.g. -VAS 6208-

Removing the oil pan

Note

Observe the general repair instructions → Chapter.

–	Remove the sound dampening system → Body work; Rep. Gr.50.

–	Place the catch pan, e.g. -VAS 6208- underneath.

–	Remove drain plug -arrow-.

–	Drain the ATF.

–	Loosen the oil pan screws alternately, and take out the oil pan.

Installing the oil pan

Installation is carried out in the reverse order. Pay attention to the following:

The drain plug with gasket ring must always be replaced → Electronic Catalogue of Original Parts.

–	Clean all the magnets in the oil pan beads. Take care that the full surface of the magnets rests against the oil pan.

–	Fit the oil pan with a new seal.

–	Tighten the oil pan screws alternately, in several stages.

–	Fill with ATF and check and top up ATF level → Chapter.

Tightening torques

¹⁾ Use new screw.

Skoda Workshop Service and Repair Manuals