skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Disassembling and assembling secondary shaft (output shaft) up to 06.03 > < Disassembling and assembling the drive shaft

Superb

Determine circlip x in front of the ball bearing of the drive shaft
Determine circlip x in front of the ball bearing of the drive shaft
–  Drive the measured rear circlip and ball bearing with the drive bushing -MP1-316- onto the drive shaft.
   
–  Determine the thickest circlip - that can be fitted - and insert.
Assign the circlip via the → electronic catalogue of original parts.
The following circlips are available:
  V35-1030
Circlip thickness (mm)
1,451,721,99
1,541,812,08
1,631,902,17

   

Disassembling and assembling secondary shaft (output shaft) up to 06.03 > < Disassembling and assembling the drive shaft