Baja F4-2.5L SOHC (2003)
1. After calling up a diagnostic trouble code (DTC), disconnect diagnosis connector terminal 8 from diagnosis terminal.
2. Repeat 3 times within approximately 12 seconds; connecting and disconnecting terminal 8 and diagnosis terminal for at least 0.2 seconds each
time.
NOTE: After diagnostics is completed, make sure to clear memory. Make sure only start code (11. is shown after memory is cleared.
WITH SUBARU SELECT MONITOR
Refer to SUBARU SELECT MONITOR for information about how to clear diagnostic trouble codes (DTCs). <Ref. to Subaru Select Monitor.>