Workshop Repair Manuals

Subaru Workshop Manuals

[PREV PAGE] [NEXT PAGE]

subaru Workshop Repair Guides


Hatchback 4WD F4-1781cc 1.8L (1983)

Body and Frame > Seats > Seat Track > Component Information > Technical Service Bulletins > Customer Interest for Seat Track: > 125893 > Feb > 93 > Front Seat - Does Not lock into L/R Tracks at Same Time > Page 2402

Page 2
background image

2.

Look closely at the lock plate pawls and the slide rail to determine whether the slide rail is misaligned by being too far forward or by being too far
towards the rear of the vehicle. (Refer to Figure 2.)

This drawing shows a slide rail that is misaligned towards the rear of the vehicle.

3.

If the outboard slide rail is too far to the rear of the vehicle, adjust forward as follows:

1)

Loosen bolt 4. (See Figure 1.)

2)

Remove bolt 2. (See Figure 1.)

3)

Insert a washer between the slide rail bracket and the floor as shown in drawing. (Refer to Figure 3.)

4)

Secure bolts 2 and 4 to the proper torque in that order.

5)

Make sure that the lock pawls now engage properly.

4.

If the slide rail is too far toward the front of the vehicle, adjust the opposite rail forward to match as follows:

1)

Loosen bolts 3 and 5. (See Figure 1.)

2)

Remove bolt 1.

3)

Insert a washer between the slide rail bracket and the floor. (Refer to Figure 3.)

4)

Secure bolts 1, 3, and 5 to the proper torque, in that order.

5)

Make sure that the lock pawls now engage properly.

Flat Rate Information

Body and Frame > Seats > Seat Track > Component Information > Technical Service Bulletins > Customer Interest for Seat Track: > 125893 > Feb > 93 > Front Seat - Does Not lock into L/R Tracks at Same Time > Page 2402

[PREV PAGE] [NEXT PAGE]