Subaru Workshop Manuals
Hatchback 4WD F4-1781cc 1.8L (1983)
Instrument Panel, Gauges and Warning Indicators > Brake Warning Indicator > Component Information > Diagrams > Diagram Information and Instructions > Page 2469
Fig. 11 Proper First Taping
Fig. 12 Proper Second Taping
Step 6: Tape the Splice
Center and roll the splicing tape. The tape should cover the entire splice. Roll on enough tape to duplicate the thickness of the insulation on the
Splicing Twisted/Shielded Cable
Fig. 15 Twisted/Shielded Cable
Twisted/shielded cable is sometimes used to protect wiring from electrical noise (stray signals). For example, two-conductor cable of this construction is
Step 1: Remove Outer Jacket
Remove the outer jacket and discard it. Be careful to avoid cutting into the drain wire or the mylar tape.
Step 2: Unwrap the Tape
Unwrap the aluminum/mylar tape, but do not remove it. The tape will be used to rewrap the twisted conductors after the splices have been made.
Fig. 16 The Untwisted Conductors
|[PREV PAGE] [NEXT PAGE]|