Impreza L Sedan F4-2.2L SOHC (1997)
1. Pulling up brush
Before assembling, press the brush down into the brush holder with your finger and secure in that position by passing a [2 mm (0.08 in) dia.
length 4 to 5 cm (1.6 to 2.0 in)] wire through the hole shown in the figure.
CAUTION: Be sure to remove the wire after reassembly.
2. Heat the rear bracket [50 to 60 °C (122 to 140 °F)] and press the rear bearing into the rear bracket. Then lubricate the rear bracket.
3. After reassembly, turn the pulley by hand to check that the rotor turns smoothly.