Impreza L Sedan F4-2.2L SOHC (1997)
5. Drive ball bearing (1) onto the rear section of transmission main shaft using ST1, ST2 and a press.
ST1 899714110 Remover, or equivalent.
ST2 499877000 Race 4-5 Installer, or equivalent.
6. Using the same tools as in step 5, install the following parts onto the rear section of transmission main shaft.
-
5th gear thrust washer
NOTE: Face thrust washer in the correct direction.
(C): Face this surface to 5th gear side.
ST1 899714110 Remover, or equivalent.
ST2 499877000 Race 4-5 Installer, or equivalent.
-
5th needle bearing race
7. Install the following parts to the rear section of transmission main shaft.
-
Needle bearing (32 x 36 x 25.7)
-
5th drive gear
-
Baulk ring
-
Sleeve (A) and hub assembly
-
Insert stopper plate (B)
-
Lock washer (22 x 38 x 2)
-
Tighten lock nuts (D) (22 x 13) to the specified torque using ST1 and ST2.
ST1 499987003 Socket Wrench (35), or equivalent.
ST2 498937000 Transmission Holder, or equivalent.
NOTE:
-
Align groove (E) inch baulk ring with shifting insert.
-
Be sure to fit pawl (F) of insert stopper plate into 4 mm (0.16 inch) dia. hole in the boss section of synchronizer hub.
-
Secure lock nuts in two places after tightening.