Impreza Wagon FWD F4-1820cc 1.8L SOHC (1995)
1. Install hinge bracket to body.
2. Insert right backrest hinge pin into hole in bracket. Tilt backrest backward until striker engages with lock.
3. Secure right backrest center hinge to body using a bolt.
4. Temporarily install left backrest side hinge to body using a bolt, and fold backrest forward to the floor.
5. Roll up mat (located at rear of left backrest), and install center hinge using a bolt.
6. Tilt left backrest until striker engages with lock, and tighten bolt [refer to step 4)].
7. Install hinges to front of cushion and tighten with bolts. Check that lock properly engages.
8. Fold backrest onto cushion and overlap trunk mat and mat at rear of backrest. While pushing down on edges of these mats, tighten screws.
CAUTION:
-
Do not allow center seat belt to get under cushion when folding cushion.
-
Ensure that side seat belt tongue is free from cushion and trim panel.
-
Before folding cushion, store seat belt in belt pocket located In backrest.
-
Lift front of cushion to ensure that cushion Is properly locked.
-
Before removing or installing backrest, pull seat belt out of backrest belt pocket.