Impreza WRX STI F4-2.5L DOHC Turbo (2007)
Shifter M/T: Service and Repair
MT Gear Shift Lever
REMOVAL
6MT
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Remove the gear shift knob.
4) Remove the console box front.
5) Remove the boot plate from body.
6) Lift-up the vehicle.
7) Remove the under cover.
8) Remove the rear exhaust pipe and muffler.
9) Remove the crossmember.
10) Remove the snap pin and washer, and then remove the reverse check cable from reverse check lever.
11) Move the transmission to right side, and then remove the joint COMPL, stay bolt and reverse check cable.
NOTE:
If the transmission is not moved, the joint COMPL and stay bolt will contact body and damage may occur.
12) Remove the cushion rubber from body.