Impreza WRX STI F4-2.5L DOHC Turbo (2007)
13) Lower the vehicle.
14) Remove the gear shift lever.
INSTALLATION
6MT
1) Insert the gear shift lever from room side.
NOTE:
After inserting the rod and stay, temporarily put them onto transmission mount.
2) Mount the cushion rubber on body.
3) Move the transmission to right side, and then install the joint COMPL and stay.
4) Install the crossmember.
5) Install the reverse check cable end, washer and snap pin to reverse check lever.
NOTE:
^
Take care to install the snap pin in proper direction.
^
Conduct the adjustment of reverse check cable before installation.