Impreza WRX STI F4-2.5L Turbo (2008)
Brake Pedal Assy: Service and Repair
Brake Pedal
REMOVAL
1) Remove the steering column.
2) Disconnect the connector from clutch switch.
3) Disconnect the connector from stop light switch.
4) Turn the stop light switch counterclockwise and remove the switch.
5) Remove the clevis pin which secures the pedal and operating rod.
6) Remove the nut which secures the clutch master cylinder.
7) Remove the bolt and nut which secures the pedal bracket.
INSTALLATION
CAUTION:
^
Perform the following steps for the stop light switch.
^
Do not install the stop light switch before performing step 2). Otherwise the switch may fall or a condition such as the light being always
lit or not lighting properly may occur.
1) Install the bolt and nut which secure the brake pedal bracket.