Legacy F4-2.5L SOHC (2003)
7. Put ST3 over pinion, and insert oil seal, then force-fit oil seal into housing using ST4.
ST1 926370000INSTALLER A
ST2 927630000STAND BASE
ST3 926360000INSTALLER A
ST4 927620000INSTALLER B
NOTE:
^
Apply specified power steering fluid to oil seal and ST3, being careful not to damage oil seal lip.
^
Push oil seal until ST3 contacts housing end face.
8. Remove ST3, and fit backing washer.
9. Force-fit ball bearing using ST3.
STY 926370000 INSTALLER A
ST2 34099FA100 STAND BASE
ST3 927640000 INSTALLER B
NOTE: Be careful not to tilt ball bearing during installation.
10. Apply genuine grease to pinion gear and bearing of valve assembly.
11. Install gasket on valve assembly. Insert valve assembly into place while facing rack teeth toward pinion.
CAUTION: Be sure to use a new gasket.