Legacy F4-2.5L SOHC (2003)
NOTE: Do not allow packing to be caught when installing valve assembly.
12. Tighten bolts alternately to secure valve assembly.
Tightening torque: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
CAUTION: Be sure to alternately tighten bolts.
13. Apply grease to sleeve insertion hole.
14. Apply grease to dust seal insertion hole.
CAUTION: Apply clean grease with clean hands. If material having a sharp edge is used for applying grease, oil seal at the inside might be
damaged.
15. Press-fit dust seal into gearbox housing while tapping it via a spanner or the like so that stepping between gearbox and dust seal is normally 2 mm
(0.08 inch).
Depth: A 2 mm (0.08 inch)
16. Apply grease to sliding surface of sleeve and spring seat, then insert sleeve into pinion housing. Fit spring into sleeve screw, pack grease inside of
screw, then install the screw.