Legacy Brighton Wagon AWD F4-2.5L SOHC (2000)
Check the high tension cables for carbon tracks (leakage) If leakage is evident, the high tension cables should be replaced and the ignition coil cleaned
(see Figure 2 and refer to Step 3).
Step 3) Ignition Coil Cleaning Procedure (if carbon track is less than 5 mm)
^
If there is any evidence of carbon, clean the surface of the ignition coil using a clean, soft rag dampened with water.
^
Permit the ignition coil to dry.
^
Clean the same area of the ignition coil using a clean soft rag dampened with Isopropyl alcohol.
^
Permit the ignition coil to dry.
Note:
Do not insert the high tension cables until the ignition coil is dry.
PART INFORMATION
The high tension cables for Impreza and Forester have changed to a silicone rubber boot which has a shiny appearance Please note that the part numbers
have not changed The Legacy and Outback high tension cables also have a silicone rubber boot.