Legacy Brighton Wagon AWD F4-2.5L SOHC (2000)
![background image](/subaru/legacy_brighton_wagon_awd/f4-2.5l_sohc/Page-1054004.png)
12. Feed the specified fluid and discharge air.
NOTE: Never start the engine before feeding the fluid; otherwise vane pump might be seized up.
13. Finally check clearance between pipes and/or hoses, as shown above.
If clearance between cruise control pump and power steering hose is less than 10 mm (0.39 inch), proceed as follows:
1. Move clamped section (A) (refer to figure above.) down to a point where pipe is close to crossmember.
Pipe-to-crossmember clearance: 10 mm (0.39 inch), min.
2. Check that clearance between cruise control pump and power steering hose is at least 10 mm (0.39 inch). If it is not, bend section (B) down
until a clearance of at least 10 mm (0.39 inch) is obtained.