Legacy GT LTD Sedan AWD F4-2.5L DOHC (1998)
(1) Apply specified hydraulic oil to O-rings and fit them into front casing.
(2) Install side plate to front casing.
CAUTION: Use care not to let side plate gall.
(3) Mount rotor onto shaft.
(4) Install 10 vanes into rotor with their nose facing toward cam ring.
(5) Install cam ring to front casing, securing with knock pins.
CAUTION: Do not use hammer to fit knock pins in position.
4. Rear cover
(1) Mount seal washer on front casing.
(2) With knock pin positions aligned, install rear cover.
Tightening torque: 16 ± 2 Nm (11.6 ± 1.4 ft. lbs.).
CAUTION: Loosely tighten bolts in the sequence (1), (3), (2), and (4) shown in figure. Then, tighten in the same sequence.
5. Spool Valve
(1) Install spring into front casing. Then, with spool valve dipped in specified hydraulic oil, install it into the front casing.
(2) Using a 5-mm dia. round bar, ensure that valve moves smoothly.
(3) Set O-ring, with grease applied to it, onto connector and secure connector to front casing.