Legacy GT LTD Sedan AWD F4-2.5L DOHC (1998)
Tightening torque: 74 ± 5 Nm (54.2 ± 3.6 ft. lbs.).
CAUTION:
-
Use care to prevent damage to O-ring at installation.
-
When tightening connector, ensure that O-ring does not protrude or get caught.
6. Check
(1) When reassembly procedures have been completed, turn shaft by hand to ensure it turns smoothly. If it binds or other unusual conditions are
evident, disassemble again and check for foreign matter trapped on sliding surfaces and improper installation. Eliminate the cause of trouble.
(2) Check followings.
Excessive play in pulley shaft
Ditch deflection of pulley
Resistance to rotation of pulley
Measurement of generated oil pressure
F: INSTALLATION
1) Install bracket on engine.
Tightening torque: 22 ± 2 Nm (15.9 ± 1.4 ft. lbs.)
2) Install oil pump on oil tank as follows outside the vehicle:
NOTE: Prior to installation, make sure that all oil is removed from oil pump, oil tank and pipe.
3) Place oil pump in vise.
CAUTION: Do not place oil pump directly in vise; use soft pads and hold oil pump lightly to protect it.
4) Install O-ring on oil pump.
CAUTION: Discard old 0-ring and replace with a new one.
5) Install oil tank on oil pump.
Tightening torque:
Bolt C: 15.7 ± 2.4 Nm (11.58 ± 1.77 ft. lbs.)
Bolt D: 18.1 ± 2.5 Nm (13.35 ± 1.84 ft. lbs.)
CAUTION: Discard old seal washer and replace with a new one.
6) Install stay to oil pump. (2500 cc model only)
