Legacy Outback Ltd Sedan F4-2.5L SOHC (2000)
6. Installation of molding:
When installing molding to windshield, align mark(B) on molding to notch (A) on ceramic print.
7. Application of primer:
1. Using a sponge, apply primer to part of glass to be adhered.
2. Apply primer to part of body to be adhered.
CAUTION:
-
Primer is hard to wipe off of body paint, instrument panel, inner trim, etc. So put masking around these areas for protection.
-
After application, let 1st primer dry spontaneously for about 10 minutes.
-
Do not touch primer-coated surface under any circumstances.
8. Application of adhesive:
1. Cut nozzle tip of cartridge as shown in figure.
2. Open cartridge and put it into a gun with nozzle attached.
3. Apply adhesive uniformly to all sides of adhesion surface while operating gun along glass end face.
9. Installation of glass:
1. Hold glass with rubber suction cups.