Legacy Outback Ltd Sedan AWD F4-2.5L SOHC (2001)
Power Steering Pump: Service and Repair
REMOVAL
1. Remove ground terminal from battery.
2. Remove pulley belt cover bracket.
3. Loosen lock bolt and slider bolt and remove power steering pump drive V-belt.
4. Disconnect connector from power steering pump switch.
5. Disconnect pipe C and suction hose from oil pump.
CAUTION:
^
Do not allow fluid from the hose end to come into contact with pulley belt.
^
To prevent foreign matter from entering the hose and pipe, cover the open ends of them with a clean cloth.
6. Remove bolts which install power steering pump bracket.
7. Place oil pump bracket in a vise, remove two bolts from the front side of oil pump.
CAUTION: Do not place oil pump bracket directly in the vise; use soft pads and hold oil pump lightly to protect the pump.