Legacy Wagon 4WD F4-2.5L DOHC (1996)
Impact Sensor: Testing and Inspection
Inspection and Replacement Standards
1. VEHICLES WHICH BECOME INVOLVED IN A COLLISION
If the vehicle equipped with an SRS airbag system is damaged in a collision, the airbag system parts must be checked and replaced in accordance
with the following standards:
After faulty parts are replaced, the warning light operation must be checked.
-
When the ignition switch is turned ON, it lights up for 8 seconds and then it goes out for at least 30 seconds.
-
The trouble code stored in memory must be erased after the check.
2. FRONT SENSOR
Inspection standard:
-
Check the front section (Refer to shaded area of vehicle in figure) for damage, regardless of whether or not airbag is deployed.
-
Check whether or not the designated trouble code is output during self-diagnosis. (Refer to "Diagnostics" Section.)
Replacement standard:
-
Bracket is deformed.
-
Housing is cracked or deformed.
-
The label (that identifies the manufacturing number) is peeled or deteriorated.
-
Harness circuit is broken, lead wire is exposed, corrugated tube is cracked, etc.
-
Front sensor determined as faulty as a result of Diagnostics.
-
Airbag is deployed.
-
Front sensor dropped to the floor/ground.