Legacy Wagon 4WD F4-2.5L DOHC (1996)
Impact Sensor: Service and Repair
1. Disarm SRS as described under Technican Safety Information.
2. Remove lower instrument cover and cover panel, then disconnect air bag connectors AB3 and AB8 below steering column. Do not connect these
again until front sensors are securely installed.
3. Remove front console box.
4. Disconnect two-pin blue electrical connector (righthand side sensor) and two-pin orange electrical connector (lefthand side sensor) from air bag
control unit.
5. Roll up floor mat and side sill cover, then remove front sensor harness from clip and protector.
6. Remove front wheels, then front mud shield.
7. Remove wiring harness clips securing front sensor harness.
Fig. 32 SRS Components