Outback F4-2.5L (2008)
2)
Remove lower nut and upper bolt and retain.
3)
Remove AT Cable Plate Assembly and retain the 2 bolts. Remove the AT Cable Bracket from the AT Cable Plate Assembly and retain the 2 bolts.
4)
Install Inhibitor Cover Front Bracket by installing lower nut and upper bolt.
5)
Install the select cable to the AT Cable Plate Assembly using the AT Cable Bracket with the 2 bolts that were retained. Install the AT Cable Plate
Assembly, Cable and Bracket to the transmission using the 2 bolts that were retained.
6)
Install Cable, Washer and Snap Pin to the range select lever
7)
Adjust the inhibitor switch
^
Set the select lever to "N" range.
^
Loosen the three inhibitor switch securing bolts.
^
Insert ST (special tool) 499267300 Stopper Pin as vertical as possible into the holes in the inhibitor switch lever and switch body.
^
Tighten the three inhibitor switch securing bolts then remove special tool.
Tightening torque: 3.4 N-m (0.35 kgf-m, 2.5 ft-lb)
8)
Adjust the select cable
