Outback F4-2.5L SOHC (2005)
Clutch Disc: Service and Repair
Clutch Disc and Cover
REMOVAL
NOTE: The illustration below is for Turbo model. However, perform the same procedure for Non-turbo model.
1. Remove the transmission assembly from vehicle.
2. Insert the ST on flywheel.
ST 499747100 CLUTCH DISC GUIDE
3. Remove the clutch cover and clutch disc.
NOTE:
^
Take care not to allow oil on the clutch disc surface.
^
Do not disassemble the clutch cover or clutch disc.
^
Be sure to mark alignment marks on the flywheel and clutch cover before removing clutch cover.
INSTALLATION
NOTE: The illustration below is for Turbo model. However, perform the same procedure for Non-turbo model.
1. Insert the ST into clutch disc and install on the flywheel by inserting the ST end into pilot bearing.
NOTE: When installing the clutch disc, be careful of its direction.
ST 499747100 CLUTCH DISC GUIDE