Outback F4-2.5L SOHC (2005)
Hydraulic Hose: Service and Repair
Clutch Pipe and Hose
REMOVAL
1. Remove the air intake chamber. (Non-turbo model)
2. Remove the intercooler. (Turbo model)
3. Drain the clutch fluid.
4. Disconnect the clutch pipe from the clutch hose and master cylinder.
5. Pull out the clamp, then remove the clutch hose from bracket.
6. Disconnect the hose from operating cylinder.
7. Remove the bracket.
INSTALLATION
Install in the reverse order of removal.
NOTE: Bleed the air of clutch fluid.
Tightening torque:
T1: 15 Nm (1.5 kgf-cm, 10.8 ft. lbs.)
T2: 18 Nm (1.8 kgf-cm, 13.0 ft. lbs.)
T3: 25 Nm (2.5 kgf-cm, 18.4 ft. lbs.)
INSPECTION
