Outback F6-3.0L (2003)
NOTE: Check wheel alignment and adjust if necessary.
Tightening torque: Refer to Specifications for tightening torque.
DISASSEMBLY
FRONT BUSHING
1. Using ST-A, B. press front bushing out of place.
ST-A, B 20099AE020 INSTALLER & REMOVER SET
1. Set ST-A in position with larger inside diameter side facing up.
2. Set rear arm with protruded bushing side facing down.
3. Place ST-B on upper side of bushing, then press bushing out of position.
REAR BUSHING
Using ST-C and bearing puller, press rear bushing out of place.
ST-C 20099AE040 INSTALLER & REMOVER SET
ASSEMBLY
FRONT BUSHING
1. Using ST-A, B. press bushing into rear arm.
ST-A, B 20099AE020 INSTALLER & REMOVER SET
1. Set ST-A in position with smaller inside diameter side facing up.
2. Set rear arm in position with outer side of vehicle body facing down.
3. Place bushing on upper side of rear arm.
4. Place ST-B on upper side of bushing, then press bushing into position.