Outback F6-3.0L (2003)
CAUTION: Install bushing with painted side facing up.
Install front bushing in the proper direction, as shown in figure.
REAR BUSHING
1. Using ST-C, D and bearing puller, press bushing into rear arm.
ST-C, D 20099AE040 INSTALLER & REMOVER SET
1. Insert bushing into bore in ST-D.
2. Set ST-C, ST-D and bearing puller in position, as shown in the figure, and press bushing into position.
INSPECTION
Check rear arm for bends, corrosion or damage.
Link Upper
Link Upper
REMOVAL
1. Loosen wheel nuts. Lift-up vehicle and remove wheel.