Outback F6-3.0L DOHC (2006)
Shifter A/T: Service and Repair
Select Lever
REMOVAL
1. Set the vehicle on a lift.
2. Disconnect the ground cable from battery.
3. Shift the select lever to "N" range.
4. Lift up the vehicle.
5. Remove the rear exhaust pipe and muffler.
6. Remove the heat shield cover.
7. Remove the cable from arm assembly.
8. Raise the pawl of clamp to remove the cable.
9. Lower the vehicle.
10. Remove the console box.
11. Remove the center console.
12. Remove the harness clips from the bracket.