Outback F6-3.0L DOHC (2006)
11. After the completion of adjustment, confirm that the select lever operates properly at all range positions.
12. Install the heat shield cover.
13. Install the rear exhaust pipe and muffler.
14. Inspect the following items. When a malfunction is found in the inspection, adjust the select cable and inhibitor switch.
NOTE: Inhibitor switch for 5AT model is not adjustable.
1. Engine starts when the select lever is in "P" and "N" range, but not in other ranges.
2. Back-up light illuminates when the select lever is in the "R" range, but not in other ranges.
3. Select lever and indicator positions are matched.
DISASSEMBLY
1. Shift the select lever to "N" range.
2. Remove the indicator light.
3. Remove the grip.
4. Remove the indicator assembly.
5. Remove the blind.
6. Shift the select lever to the N range, and then remove the detent spring.
7. Remove the bolt, and separate the guide plate upper from plate lower.
