Outback L.L.Bean Edition AWD F6-3.0L (2002)
Trunk / Liftgate Latch: Service and Repair
Rear Gate Latch
Rear Gate Latch Assembly
REMOVAL
1. Disconnect ground cable from battery.
2. Remove the rear gate lower trim. <Ref. to REMOVAL, Rear Gate Trim.>
3. Remove the rear gate key cylinder rod.
4. Remove the nut holding the rear gate outer handle. Remove the stay.
5. Remove the three bolts.
6. Remove the two connectors and pull out the latch.
INSTALLATION
Install in the reverse order of removal.
NOTE: Make sure the lock operates properly after installation.
INSPECTION
1. Make sure the rod is not deformed.
2. Make sure the lever and rod work smoothly.
