Outback L.L.Bean Edition AWD F6-3.0L (2002)
12) Remove idler sprocket. (Upper)
13) Remove timing chain (LH).
14) Remove idler sprocket. (Lower)
B: INSTALLATION
CAUTION:
-
During installation, be careful to prevent foreign objects from attaching to or mixing with assembled components.
-
Apply engine oil to chain guide, chain tensioner lever, and idler sprocket during installation.
1) Preparation for installation of chain tensioner.
(1) Put the screw, spring, pin and tension rod into the tensioner body.
(2) While pressing tensioner onto rubber mat, twist it left and right to shorten tension rod. Then set a thin pin into the holes between tension rod
and tensioner body to hold it.
NOTE: Carry out the work on rubber mat or other nonslip material.
2) Using ST, align "top mark" on crankshaft sprocket at 9 o'clock position as shown in the figure.
